Xylem H-2192 - Manual (Page 41)

Chapter 5
Menu Mode Reference
5.1 Menu Mode Reverence
The easiest way to setup and test the modem is to use the built in menu mode. To enter the menu
connect a PC to the serial port and using a terminal emulation program like Hyper Term running at
9600 baud, enter the command AVMENU. The main menu should be displayed as shown below.
The example below is for the H-2192, the Cell phone option.
5.2 Remote Access
The modem menus and commands can also be accessed remotely. Normally when calling a site that
has an H-219X, the intent is to communicate with a device connected to the serial port of the H-
219X. However if the device connected to the H-219X is in a sleep state, then the H-219X is
accessed by typing in commands for the H-219X. Normally the AVMENU command is used to
access the menus of the modem. As long as ‘AV’ commands are sent to the remote H-219X the
characters will not be passed on to the connected device.
If the connected is an XL series data logger and it is asleep, pressing any key other than ‘AVxxx’
will cause the characters to be sent out the serial port and wake up the XL data logger.
H-219X
Menu Mode Reference 5-1