Xylem H-2192 - Manual (Page 47)

5.7 RF Radio Menu
The RF radio interface was designed for the ‘Data Radio, DL3400'. Other radios may be used but
a special cable will be required.
H-2191 RF Radio Menu (ESC to Exit)
P - Radio Power On/Off: Off (Manual Off)
I - Radio ID Code: 1234
Last Time Update: 00:00:00
N - Radio Turn On Time: 06:00:00
O - Radio Turn Off Time: 18:00:00
V - Radio Turn Off Voltage: 12.25
Enter Option ->
P - Radio Power On/Off:
This option is used to set the current power mode and to see the current status of the power for the
radio. The modes are Off, On, and Auto.
Power Modes:
Off
In this mode the radio power is forced off. No matter of other settings the radio will be
powered down.
On
In this mode the radio power will turn on as long as the battery voltage is greater than the
value of the ‘Radio Turn On Voltage’ listed below. If the battery voltage drops lower than
the ‘Radio Turn On Voltage’ then the radio power will turn off.
Auto
In this mode the power will turn on and off based on the programmed turn on time and turn
off time. This option helps manage the modem power to conserve battery power. The radio
could be powered up during normal office hours when the unit would need to be called, and
off at other times to save power.
I - Radio ID Code:
This option is used to enter the 2 to 4 digit ID code for the site. When calling the site the push to talk
is pressed and held and then the ID code is entered. After entering the ID code, release the push to
talk button. If the called site was in range and able to decode the ID then it will speak the ID
message and the data for the last measurement.
H-219X
Menu Mode Reference 5-7