Xylem H-2192 - Manual (Page 39)

Description: This is a GSM only command and sets the username if required for the GSM
provider.
Command: PASSWORD
Description: This is a GSM only command and sets the password if required for the GSM
provider.
Command: PORT
Description: This command sets specifies the TCP port number which the modem is going to
listen for incoming connections. Note: If you specify port 0 it will disable incoming
data connections.
Command: IPADDRESS
Description: This command returns the current IP address assigned to the modem. If the address
listed is 0.0.0.0 then the cell modem isn't powered or the cell provider hasn't assigned
it an IP address.
4.7 VHF / UHF Radio Commands
Command: RADIOON
Description: This command is used to turn on the radio power supply. Note that if the measured
battery voltage is less than the ‘Radio Low Battery’ setting the radio will
automatically turn off.
Command: RADIOOFF
Description: This command is used to turn off the radio power supply.
Command: RADIOAUTO
Description: This command is used to turn the radio power supply on and off automatically based
on the current time.
Command: RADIOTURNONTIME
Description: This command is used to set the radio turn on time. The default is 06:00:00 so the
radio would turn on at 6 AM if the radio power mode is set to “Auto”.
Example: AVRADIOTURNONTIME=08:00:00
If the command is issued without the time option, then the current radio turn on time is
returned.
H-219X
Modem Command Reference 4-9