5 customer interface, Customer interface, Slot j2 2 – GE Industrial Solutions TLE Series 225-500 Installation Guide User Manual
Page 48: Ph snmp/web plug-in adapter (option), Slot j3, Slot j4, Customer interface board (standard), Slot j5, Customer interface board (option), Attention
Critical Power
Modifications reserved
Page 48/54
GE_UPS_ISG_TLE_SUL_M22_M50_1US_V010.docx
Installation Guide TLE Series 225 - 500 UL S1
5 CUSTOMER INTERFACE
Fig. 5-1 Connectivity rack and Serial port J35µP – RS232
TLE Series 225 - 500 has the following equipment‟s:
-
Serial Port J35µP - RS232 (see Section 5.1).
-
Connectivity rack ready for the installation of four connectivity boards [max. two boards
“Customer Interface” (see Section 5.2) and max. two boards “3-ph SNMP/WEB Plug-in Adapter” as
described in the picture below].
Possible connectivity configurations with TLE Series 225 - 500
Fig. 5-2 Connectivity rack
Slot J2 2
nd
3-ph SNMP/WEB plug-in adapter (option)
Slot J3
1
st
3-ph SNMP/WEB plug-in adapter (option)
Slot J4
1
st
Customer Interface board (standard)
Slot J5
2
nd
Customer Interface board (option)
ATTENTION !
The installation of any option board must be performed by QUALIFIED SERVICE
PERSONNEL.
Prior to the installation, connection and cabling of any option board the UPS
must be COMPLETELY POWERED DOWN and all the power sources that will be
connected to the option board must be DE-ENERGIZED.
Option board shall be connected only to Safety Extra Low Voltage circuits (SELV
for IEC-UL-CSA60950-1): voltage up to 30Vac / 42.4Vpk or 60Vdc maximum and
galvanically separated from AC Utility supply.
J35µP - RS232
Connectivity rack
TLE Series 225 & 250
1
2
TLE
S_UL
_225-
500_
S1_
UPS
con
nec
tivity
_01
TLE Series 400 & 500
TLES_UL_2
25-250_S1
_UPS conn
ectivity_01
Q1
1
2
I ON
0 O
FF
Q2
I ON
0 O
FF
- +
J35µP - RS232
Connectivity rack
Q1
I ON
0 O
FF
Q2
I ON
0 O
FF
1
2
-
+
J35µP - RS232
Connectivity rack
SGS_600
_S2_Co
nnectivi
ty rack_01
SNMP card
J3
J2
J5
J4
16
15
4
19
18
17
20
9
8
7
6
5
14
13
12
3
2
1
22
11
21
10