SCANTECH ID (Champtek company) Discovery SG-20 - Manual (Page 58)

Ethernet Configuration 50
6.1 ETHERNET NETWORK CONFIGURATION
6.1.1 Preface
The SG-20/Ethernet is provided with a converter module which lifts the
standard Discovery communication to Ethernet level. The unit uses IP protocol
for network communications. The supported protocols are ARP, UDP, TCP,
ICMP, Telnet, TFTP, DHCP, HTTP, SNMP, and BOOTP (TCP for connection-
oriented stream applications and UDP for datagram applications).
The main benefit is providing network connectivity.
The unit (P/N A360103/4/5 or newer) is linked directly to your Local Area
TCP/IP Network.
IP addressing and configuration can be done through a Telnet session, by
means of Scantech’s utility U-Start or by using the 4 buttons (from P/N
A360104 onwards, see section 6.4).
IMPORTANT
The network cabling, hub etc. is supplied and installed by the
Scantech Distributor.
The SG-20/Ethernet is shipped with default IP address set to
0.0.1.0, i.e. DHCP enabled.
The original standard Discovery (RS232/422/485 with P/N
A360102), is not field upgradable to Ethernet.