4 ethernet configuration, 2 installing the discovery sg-20, 1 removing the cover of the discovery – SCANTECH ID (Champtek company) Discovery SG-20 User Manual
Page 39: Installing the discovery sg-20, Ethernet configuration, Removing the cover of the discovery
Scantech-ID Discovery SG-20
31
IMPORTANT
Connect the network box to an outlet which is on the same circuit
as the backoffice system. This prevents possible damage due to
differences in ground potential.
When the network box is correctly installed, the power LED on the front is
illuminated.
4.1.4
Ethernet configuration
The Ethernet configuration is an option on the Discovery. For more details see
Chapter 6.
4.2
INSTALLING THE DISCOVERY SG-20
4.2.1
Removing the cover of the Discovery
Removal of the cover is usually not required. Only if your Discovery’s version is
below A360104 and you need to set the
jumpers or make some special connections
you may have to open the unit.
For installation of the connections of the
Discovery, remove the cover from the rear
panel as follows.
1.
Loosen the two screws that keep the
cover in place
2.
Remove the cover from the Discovery.
3.
Disconnect the speaker and cable from
the cover