Ocean Optics RaySphere 1700 Install - Manual (Page 50)

7: Classifying the Solar Simulator and Displaying the Results
40 RAYSPHERE-1700-02-201304
Saving Results
All measured results can be saved using the -save all function ( ) in the System tab of the software. A
Save wizard appears. It is recommended to enter the serial number of the tested solar simulator or
anything else to identify the solar simulator by another specific notable feature.
A test report is generated automatically from the data.
Validating a Solar Simulator
The following procedures enable you to validate a flashing or continuous light-emitting solar simulator.
For best results, follow the applicable procedure and check the resulting test report (see
Validating a
Solar Simulator ).
Using RaySphere with a Flash Solar Simulator
► Procedure
1. Place the assembled RaySphere main body close to the test plane so that its aperture is centered in
the middle of the test plane.