Chapter 6, Using preconfigured configuration files, Overview – Ocean Optics RaySphere 1700 Install User Manual
Page 45: How to use configuration files, Using preconfigured, Configuration files, Using, Preconfigured configuration files
RAYSPHERE-1700-02-201304
35
Chapter 6
Using Preconfigured
Configuration Files
Overview
RaySphere is designed as a tool which should be usable for beginners in optical measurement. To do this,
preconfigured files, named config-files, have been created which contain all information needed for
setting the RaySphere. Loading these preconfigured files into the RaySphere software enables you to
perform measurements under previously defined conditions.
How to Use Configuration Files
► Procedure
1. Load the configuration file by pressing the
button in the RaySphere software. All relevant
parameters are now set.
2. Measure a dark spectrum.
3. To start a measurement, press the
button (to get the system into ready status. A spectrum will
be recorded automatically when the next flash or trigger signal is detected
.
A complete procedure for validating a solar simulator using a preconfigured configuration file is provided
in
and in the RaySphere Quick Start Instructions (see
).
Note
You are allowed to change settings in the RaySphere software after loading a configuration file.