Ocean Optics RaySphere 1700 Install - Manual (Page 24)

3: Software Operation
14 RAYSPHERE-1700-02-201304
Setting Meaning
Operation Mode Changes the mode of operation:
• Continuous/ValueFind – optimizes the values for trigger levels, delays and
integration times
• Autotest/SingleSpec – Used for single measurements of the solar simulator
* The values for trigger level and delays are stored in RaySphere’s electronics to ensure immediate
response and minimize jitter.
Photocurrent Graph
The photocurrent is recorded by a photodiode, digitalized, and displayed in the graph on the Trigger
Settings / Photo Current page as shown in the example below:
The time evolution of a flash from a solar simulator is displayed on the graph. This graph contains the
following components:
• X-axis – time in ms.