Ocean Optics RaySphere 1700 Install - Manual (Page 30)

3: Software Operation
20 RAYSPHERE-1700-02-201304
Message Type Message Meaning
Failed to write to device [error " + error type +
"Command:" + command content]
Failure to write a command to the
trigger device
Recording The first [or second] spectrometer needs
Record.
The spectrometer has no spectrum data
Classification needs irradiance data Both of the spectrometers have no
spectrum data
Measurement [spectrometer name] needs calibration An absolute irradiance calibration has
not been loaded
[spectrometer name] the most recently
acquired spectrum was saturated
The spectrum data is saturated
[spectrometer name] detector temperature is
[degree] Celsius degree
The actual TEC degree is different from
the target degree
It will take [20 minutes minus the elapsed
time] more minutes to warm up done
Warm-up time is not reached within 20
minutes
Note
You can perform tests and generate a certificate while a warning is present. However, the
warnings are listed in the certificate and inaccuracies might increase if a warning was present
during certification.