B&B Electronics ZXT9-RM-KIT - Manual - Manual (Page 11)

Document Number: pnZXTxRM-0712m
Page
11
Parity = None
Stop bit = 1
Figure 2-4 Push Button
2.5.7 USB Connector
The USB connector is located on the circuit board inside the radio modem enclosure. It is
used to connect a PC to the radio modem to perform configurations and firmware updates.
The connector is a type b female. Any commercially available USB cable can be used to
connect to the radio modem. Figure 2-5 shows the USB Connector location.
Figure 2-5 USB Connector
2.5.8 Terminal Block
The terminal block is used to connect serial signals and power. Figure 2-6 shows the
location.