Rainbow Electronics ATtiny26L - Manual (Page 32)

32
ATtiny26(L)
1477B–AVR–04/02
oscillator is intended for calibration to 1.0, 2.0, 4.0, or 8.0 MHz. Tuning to other values is
not guaranteed, as indicated in Table 14.
External Clock To drive the device from an external clock source, XTAL1 should be driven as shown in
Figure 30. To run the device on an external clock, the CKSEL Fuses must be pro-
grammed to “0000” and PLLCK to “1”. By programming the CKOPT Fuse, the user can
enable an internal 36 pF capacitor between XTAL1 and GND.
Figure 30. External Clock Drive Configuration
When this clock source is selected, start-up times are determined by the SUT Fuses as
shown in Table 15.
Table 14. Internal RC Oscillator Frequency Range.
OSCCAL Value
Min Frequency in Percentage of
Nominal Frequency
Max Frequency in Percentage of
Nominal Frequency
$00 50% 100%
$7F 75% 150%
$FF 100% 200%
Table 15. Start-up Times for the External Clock Selection
SUT1..0
Start-up Time from
Power-down
Additional Delay from
Reset (V
CC
= 5.0V) Recommended Usage
00 6 CK – BOD enabled
01 6 CK 4.1 ms Fast rising power
10 6 CK 65 ms Slowly rising power
11 Reserved
EXTERNAL
CLOCK
SIGNAL
PB5 (XTAL2)
XTAL1
GND