Printronix Online Data Validator - Manual (Page 30)

Chapter 1 Installation and Removal
30
Figure 14. Attaching the Validator/Bracket Unit to the Printer
3. Face the front of the printer while installing the validator/
bracket unit.
4. Using four M4x10mm screws, attach the validator/bracket unit
to the printer frame as shown in Figure 14.
5. Tighten the four screws finger tight. You will adjust the
validator/bracket unit in a later step using the 3mm hex key
(provided).
183341a
Validator/Bracket Unit
M4x10mm
Screw (4)