Printronix Online Data Validator - Manual (Page 18)

Chapter 1 Installation and Removal
18
Install the Ferrite
1. Loosen the two captive screws securing the top of the frame
side cover. (Figure 2.)
2. Tilt the frame side cover back from the top and lift it until the
tabs along the lower edge disengage from the slots in the
printer frame.
Figure 2. Removing the Frame Side Cover
183454a
ETH ERNET
PARAL LEL
USB
GPI0
RS2 32
STATUS DEBU G
Captive Screw (2)
Frame Side Cover