Printronix Online Data Validator - Manual (Page 25)

Install the Ferrite
25
Figure 9. Position the Ferrite
15. On the electronics side of the printer, position the ferrite on top
of the upper DC motor. (Figure 9.)
16. Route the power/data cable through the wire saddle as shown
in Figure 9.
17. Plug the P10 connector end of the power/data cable into the
J10 receptacle on the controller board.
NOTE: For SL5000r/T5000r Energy Star models see Figure 10 on
page 26.
183461a
J10
Power/Data Cable
Ferrite
Upper
DC Motor
Wire Saddle