EVS IPDirector Version 6.2 - June 2013 CONTROL PANEL User Manual - Manual (Page 75)

4.5. Loading a Playlist
4.5.1. How to Load a Playlist via the Playlist Name
or LSM ID
You can load a playlist from the Clip-List tab by entering its playlist name or LSM ID.
To do so, proceed as follows:
1. Assign a player channel or the Software Player to the Control Panel.
2. Do one of the following actions:
◦ Enter the playlist name in the Playlist Name field of the Clip-List tab . If the
playlist name entered by the operator is found several times in the database, the
last playlist created with that name in the database is considered.
◦ Enter the playlist LSM ID in the Playlist LSM ID field of the Clip-List tab
3. Press ENTER.
Tip
When the users enter only two digits in the LSM ID field, e.g. "1" and "5", and
press ENTER, the system automatically loads the local playlist if it exists.
4.5.2. How to Load a Playlist from the Database
Explorer
To load a playlist on a channel from the Database Explorer, proceed as follows:
1. Assign a player channel or the Software Player to the Control Panel.
2. Select the playlist from the Bins or the Playlists view of the Database Explorer.
3. In the Playlists view of the Database Explorer, select the requested playlist in the
Elements grid.
4. Drag it to the Playlist Name field of the Clip-List tab.
Note
Dragging it into the clip-list grid would insert the playlist into the previously
loaded one.
IPDirector - Version 6.2 - User Manual - Control Panel
4. Loading Media 65