EVS MulticamLSM Version 10.04 - January 2011 Configuration Manual - Manual (Page 58)

Issue
10.04.A
EVS Multicam – Version 10.04 – Configuration Manual
EVS Broadcast Equipment SA – January 2011
50
When the parameter is set to “Play through”, Multicam will still countdown to the
OUT point, but will keep playing through this point. In a clip, Multicam always
freezes on the OUT point (or OUT point + Post-Roll duration when Post-Roll mode
is enabled).
3.8.12 F
REEZE ON
C
UE
P
OINTS
Possible values: No (default) / Yes
The purpose of this functionality is to allow marking cue points on any field of a
record train and freeze on the cue point when the playback reaches it. This is
similar to the freeze on OUT point functionality but because it will be done on cue
point, you will be able to freeze on any field (impossible with OUT points).
When playing record trains where cue points have been marked, the playout
freezes on the cue point if the parameter is set to “Yes”. It plays through if the
parameter is set to “No”.
The Post-Roll parameter is not taken into account for this functionality.