Audio meters on osd, Audio meters adj. (db), 4 network settings – EVS MulticamLSM Version 10.04 - January 2011 Configuration Manual User Manual

Page 15: Clip edit by network, 5 clip management settings, Default copy/move, Network settings, Clip management settings

EVS Multicam – Version 10.04 – Configuration Manual

EVS Broadcast Equipment SA – January 2011

Issue 10.4.A

UDIO

ETERS ON

OSD

Possible values: Yes (default) / No
This parameter enables/disables the display of audio meters at the bottom of each

output monitor.

UDIO

ETERS

(

Possible range: -83.2dB to 0dB. Default: 0dB
This parameter allows adjusting the sensitivity of audio meters on the OSD of the

output monitors. A positive value means that the meters will be more sensitive.

2.2.4 N

ETWORK

ETTINGS

You can also define the Clip edit by network setting on page 3.1, F6 of the setup

menu on the Remote Panel. You will find a description of these settings in the

Multicam user manual.

LIP

DIT BY

ETWORK

Possible values: Disable (default) / Enable
If this function is enabled, other users on the network can trim, rename, delete,

etc. your clips, or modify the keywords and ranking assigned to your clips. If

disabled, only the local operators can modify or delete clips on the server and edit

their metadata.

2.2.5 C

LIP

ANAGEMENT

ETTINGS

You can also define most of the Clip management settings on pages 3.1 to 3.3 of

the setup menu on the Remote Panel. You will find a description of these settings

in the Multicam user manual.

EFAULT

OPY

OVE

The Default Copy/Move parameter allows specifying whether the copy operations

should be executed preferably using the SDTI or the HCTX GigE network.
If the value selected is ‘SDTI’, the copy operations are first executed through the

SDTI network. If the SDTI network is temporarily unavailable, the transfer is then

tried through the HCTX GigE interface. Transfers to GigE targets will always be

performed via the HCTX GigE interface.
If the value selected is ‘GbE’, the copy operations are first executed via the HCTX

GigE interface. If the transfer is not possible (ports not connected, IP address

unknown, no more connection ports are available), the transfer is then tried

through SDTI.