EVS MulticamLSM Version 10.04 - January 2011 Configuration Manual - Manual (Page 34)

Issue
10.04.A
EVS Multicam – Version 10.04 – Configuration Manual
EVS Broadcast Equipment SA – January 2011
26
2.7 RS422 PROTOCOL SETTINGS (PAGE 5)
In the Setup Configuration module (SHIFT-F2), press the Page Down key until you
access the page 5. It displays the VarID settings for the VDCP protocol.
These settings make it possible for the VDCP protocol to use the VarID to access
the clip IDs on a server or XNet network.
Important:
The settings in this page are only applicable to the VDCP protocol.
2.7.1 D
ISPLAY
-
ONLY
W
INDOW
This page is only for display. The settings displayed are extracted from the
‘varid.ini’ file and can only be edited in this file. In case of error or undefined
values, the default setting values are used.
2.7.2 S
ETTINGS
For more information on the settings, refer to the section ‘VarID Configuration
File’, on page 27.
Note
If a setting is changed through one serial link via the new serial
command, the result will be displayed accordingly in the setup screen.