EVS MulticamLSM Version 10.04 - January 2011 Configuration Manual - Manual (Page 38)

Issue
10.04.A
EVS Multicam – Version 10.04 – Configuration Manual
EVS Broadcast Equipment SA – January 2011
30
2.8.2 S
ETTINGS
D
ESCRIPTION
The HCTX Gigabit connection settings are described in the table below:
Port #1 / Port #2
IP Address Specifies the IP address to connect to port 1 / port 2 of the
Gigabit Ethernet connection on the server:
• The IP addresses of both HCTX GigE ports cannot belong
to the same subnet mask. Doing so would return an error
message.
• The IP addresses 0.0.0.0 and 255.255.255.255 are not
allowed.
Subnet Mask Specifies the range of logical addresses within the address
space assigned to the Gigabit Ethernet network.
In the screenshot, the logical addresses available within the
network are from 128.1.254.1 to 128.1.254.254.
Default Gateway Specifies the IP address of the router on the Gigabit Ethernet
network that serves as an access point to external networks.
FTP Login
User name Specifies the user name for an FTP access to the server via
the Gigabit Ethernet connection.
Password Specifies the password for an FTP access to the server via
the Gigabit Ethernet connection. The password is not hidden.
Note
The modifications of parameter values in this screen are not applied when
you leave the field. You need to select the APPLY command at the bottom
right of the screen (or to press ALT+A on the keyboard) and press ENTER
to apply the modifications.
2.8.3 L
OST
G
IGABIT
N
ETWORK
C
ONNECTION
If a problem is detected on the GigE connexion during operation, the following
message is displayed on the Remote panel, OSD and VGA:
‘ W a r n i n g : G i g E c o n n e c t i o n h a s b e e n l o s t .
[ E n t e r ] : C o n t i n u e ’
In such a case, the message !Not detected! also appears at the top of page 6.