EVS XSense Version 10.04 - January 2011 Operating Manual - Manual (Page 100)

XSense – Version 10.04 – Operating Manual
EVS Broadcast Equipment – January 2011
Issue
10.04.A
91
11.6 NAMING A PLAYLIST OR AN ELEMENT IN
A PLAYLIST
You can name a playlist from the VGA Playlist Bank screen or from the VGA
Playlist screen.
11.6.1 H
OW TO
N
AME A
P
LAYLIST
F
ROM THE
VGA P
LAYLIST
B
ANK
S
CREEN
To name a playlist from the VGA Playlist Bank screen, proceed as follows:
1. From the Clip screen, press END to go to the Playlist Bank screen of the
requested page.
2. Press the down arrow several times until the playlist to name is selected.
3. Type the desired name on the keyboard.
It appears in the Name field at the bottom of the screen. Use
to delete the last character, or ESC to clear the entire field.
4. Press F1 to assign the new name to the current playlist.
The playlist name will appear in the title bar next to the playlist number.
11.6.2 H
OW TO
N
AME THE
C
URRENT
P
LAYLIST ON THE
VGA
P
LAYLIST
S
CREEN
To name the current playlist from the VGA Playlist screen, proceed as follows:
1. Press the F10 key on the keyboard to open the VGA Playlist screen.
The current playlist is displayed.
2. Type the desired name on the keyboard.
It appears in the Name field at the bottom of the screen. Use
to delete the last character, or ESC to clear the entire field.
3. Press SHIFT+F1 to assign the new name to the current playlist.
The playlist name will appear in the title bar next to the playlist number.
11.6.3 H
OW TO
N
AME THE
C
URRENT
E
LEMENT IN THE
L
OADED
P
LAYLIST
Note
Naming the current element of the loaded playlist will affect the original
clips.
This function is only available when the playlist is active in Playlist Edit mode