AASTRA 6730i (Version 3.2) User Guide EN - Manual (Page 132)

Managing Calls
126
41-001376-00 Rev 01 – 06.2013
Configuring CFWD Using the Aastra Web UI
Use the following procedure to configure CFWD using the Aastra Web UI.
Aastra Web UI
1. Click on Basic Settings->Preferences->General.
2. In the “Call Forward Key Mode” field, select a call forward mode to use on the phone. Valid values are: Account, Phone,
Custom. Default is Account.
• Account - (default) The account mode allows you to configure CFWD on a per account basis. Pressing a configured
CFWD key applies to the account in focus.
• Phone - The Phone mode allows you to set the same CFWD configuration for all accounts (All, Busy, and/or No
Answer). When you configure the initial account, the phone applies the configuration to all other accounts. (In the
Aastra Web UI, only the account you configured is enabled. All other accounts are grayed out but set to the same
configuration.) Using the Aastra Web UI, if you make changes to that initial account, the changes apply to all accounts
on the phone.
• Custom - The Custom mode allows you to configure CFWD for a specific account or all accounts. You can configure
a specific state (All, Busy, and/or No Answer) for each account independently or all accounts. On the 6730i, you can
set all accounts to ALL On or ALL Off.
Note:
If there is only one account configured on the phone, then the mode setting is ignored and the phone behaves as if the
mode was set to “Phone”.
3. Click Save Settings.
4. The changes takes affect immediately without a reboot.