AASTRA 600d for Aastra 800 and OpenCom 100 User Guide EN - Manual (Page 49)

Basic Functions
47
When using a headset (Bluetooth or cable connected) and the handsfree key is
pressed on the mobile unit, the call is definitely continued via the loudspeaker of the
mobile unit.
If the mobile unit and the Bluetooth headset become disconnected during a call, a
message appears on the display. You can decide whether you wish to continue the
call with a cable-connected headset or on the mobile unit itself or whether to end the
call.
Subscribing / Renaming / Unsubscribing Bluetooth Headset
Checking in
To do so, switch the headset into the “Pairing mode”. Please refer to the user guide of
the headset to do so.
1. Switch the function on (On) in the > Settings > Bluetooth > BT Status menu.
2. Open the > Settings > Bluetooth > Subscribe headset menu and then press
the New softkey.
3. The name of the headset found appears on the display. Confirm the display with
Ok and enter the headset PIN.
Now the headset is checked in and the symbol appears in the upper line of the
display.
You determine the respectively active headset in the > Settings > Bluetooth >
Select headset menu.
Renaming
Select the menu entry
> Settings > Bluetooth > Subscribe headset > [Headset
name] > Edit.
Checking out
Select the menu entry
> Settings > Bluetooth > Subscribe headset > [Headset
name] > Delete.
Telephoning via the Bluetooth Headset
Accepting a call
Press the corresponding “call key” on the headset or the
receiver key on the
mobile unit. The symbol appears.