The device menu, Information on display symbols in the device menu – AASTRA 600d for Aastra 800 and OpenCom 100 User Guide EN User Manual
Page 102
The Device Menu
100
The Device Menu
This chapter presents all essential features available on the mobile unit and the
Aastra 800 / OpenCom 100 communications system. Because the communications
system also supports the operation of cord-connected and other cordless telephones,
some menu entries are named differently, although they serve the same purpose. The
following descriptions offer more information.
Some menu entries are only shown on your telephone when you belong to a user
group authorised to use the corresponding feature. Contact the system administrator
when you have questions on specific features or are not able to use a feature satisfac-
torily.
Alongside the Device menu, there are state-dependent menus that you, e.g. can
access during a call, to use features available in that device state. For more infor-
mation, please refer to the chapter entitled Telephoning starting on page 63.
To call the Device menu do the following:
•
Press
briefly when idle.
•
When idle, press the
end key and select Menu.
Information on Display Symbols in the Device Menu
Save
When you adjust settings in a menu, you have to open the
respective settings window with the Ok softkey. Your entry is
then saved with the
softkey.
Information
You can access additional information on the entries via the
softkey.
Options
Use the
softkey to open other sub-menus (e.g. Delete, Edit).
Esc Use
the
Esc (Escape) softkey to cancel entries and/or go a step
back in a menu.
Ok Use
the
Ok softkey to confirm a selected function or entry.
Call
When you press the
softkey an entry is either dialled directly
or goes into pre-dialling.