AASTRA 600d for Aastra 800 and OpenCom 100 User Guide EN - Manual (Page 133)

The Device Menu
131
Out of range: Red LED flashing quickly when you leave the radio range
of the system.
Charge indication: LED lights up orange when the battery is charging,
changing to green when charging complete.
Info: Slowly flashing red LED, e.g. when there is a new entry on the caller
list.
Handsfree: Green LED lights up when the loudspeaker is on.
Appointment: Slowly flashing red LED when appointment signalled.
Alarm clock: Slowly flashing red LED when wake-up time signalled.
List access: the caller list and / or the re-dial list are usually managed on your mobile
unit (setting: Local). If a list is also stored on the communications system
(setting: PBX), you can select which list you wish to display. When Automatic is
selected, the device always shows the PBX list (if available) of the communica-
tions system. If this list is not available, Local is automatically selected.
Selecting the PBX list (or Automatic / PBX) is a good idea if your mobile unit is
operated parallel with the corded telephone. This means that both devices
have access to the same list and changes are shown on both devices.
Device options
Silent charging: The mobile unit does not signal any calls as long as it is on the
charger. As soon as you remove it, calls are signalled again. The calls are
recorded on the caller list. Silent charging does not apply to charging
via the USB port (available on the Aastra 620d/630d).
Auto. key lock: When this function is active, the keypad lock is automatically
switched on if you do not use the device for more than 60 seconds.
Charger answer (charger): If this function is active, the mobile unit automati-
cally accepts a call when it is taken from the charger.
Auto answer (call): This function has the mobile unit automatically accept a
call. You only activate this feature if your work procedures necessitate it,
as it could enable a caller to listen in without your noticing. To be on the
safe side, the automatic call acceptance is introduced with 3 notification
tones and a quickly blinking green LED signals the connection.
The function is useful for being immediately informed of important
things (e.g. when on call). In addition, when operating the mobile unit,
this function can be used more easily with a headset. Press change to