AASTRA 600d for Aastra 800 and OpenCom 100 User Guide EN - Manual (Page 121)

The Device Menu
119
Note: All calls for the call numbers of your device are forwarded. If a number is
in use on more than one telephone, then calls made to any of the other tele-
phones will be forwarded as well.
Divert MSN (MSN call forwarding): Use the “Divert MSN” (MSN = Multiple Subscriber
Number) to forward incoming external calls per MSN to external destina-
tions. Several MSNs can be grouped together (this is configured by the system
administrator) and forwarded to a common destination number. A list of the
configured MSNs and MSN groups is displayed.
Immediately / After delay / Busy: Select the desired forwarding type.
Dest.: Enter the external call number to be forwarded to. For the “Divert MSN”
type of call forwarding, the (external) destination number is always
entered without the area code.
On/Off: Switching call forwarding on or off. Active call forwarding is indicated
by a “+” sign. This is followed by the call forwarding destination. A “?”
preceding the entry, (e.g. ? MSN Group 1), means that call forwarding is
active for only some MSNs or that there are different call forwarding
types activated for this group.
Note: If “Divert MSN” is executed in the exchange (= external call forwarding;
configured by the system administrator), it can take a few seconds after config-
uration for call forwarding to be activated in the exchange.
Divert door (door call forwarding): This is where you can programme “Divert call
immediately” for door calls. If several doorbells are configured on the commu-
nications system, first select the doorbell whose calls are to be diverted. The
number of doorbells available and with which names they are listed in the
menu, depends on the type of entrance intercom. Consult your system admin-
istrator if you have questions concerning the configuration of the doorbells.
Dest.: Enter the call number you wish to forward to (for entering the call
number, please refer to the chapter entitled External Seizure and Entry
of Call Numbers starting on page 54).
On/Off: Switching call forwarding on or off. Active call forwarding is indicated
by a “+” sign. This is followed by the call forwarding destination.
Remote divert (call diversion for): You can also configure call forwarding for other
Aastra 800 / OpenCom 100 users. Programming call forwarding for a virtual call
number is also possible (please refer to Call for a virtual call number (Tele Sec-
retary) on page 74 also). In order to do so, “Call forwarding for other user”