beautypg.com

The device menu – AASTRA 600d for Aastra 800 and OpenCom 100 User Guide EN User Manual

Page 134

background image

The Device Menu

132

switch on or off.
The following options can be configured:

Time: you can set the length of time after which a call is automatically

accepted: Off, 0 ... 20 seconds.
Please note: if your device supports the text messages and / or
paging features, do not enter a value any less than 3 seconds.

Handsfree: the call can be accepted in the handsfree mode (loud-

speaker is activated). Using the setting In charger only or
Always differentiates whether or not handsfree is switched on
only when the mobile unit is in the charger or whether it is also
switched on when, e.g. it is being carried.

Microphone: the call can be accepted automatically with or without the

microphone switched on. The microphone can, however, be
switched on with the

softkey after taking the call.

LED indications: this is for switching the LED display on or off during a

connection.

Attention tone: the notification tone at the begin of the automatic call

acceptance can switched on or off with this.

Auto quick hook: if this feature is activated, this destination is immediately

dialled by pressing and holding a speed dial key (see page 99). The pre-
requisite is that the associated phone book entry only contains one des-
tination (personal, office, mobile, e-mail or fax). Otherwise the list of the
entries is provided in pre-dialling.

Voice box no.: This is where you save your voicebox call number. Press the number 1

long and the call number is dialled. If the call number of the voicebox is
managed by the telephone system this setting is not available.

Bluetooth (available on the Aastra 620d/630d)

BT Status: Shows whether Bluetooth is switched on or not. Press the Edit

softkey to switch on or off.

Select headset: Select the headset you wish to use from the list of subscribed

headsets.

Subscribe headset: Press the New softkey to subscribe a new headset for use

on your mobile unit. Carry out the steps necessary for the headset (see
headset user guide). The mobile unit searches for Bluetooth devices