Yamaha mcx-1000 - Manual (Page 88)

Creating CDs
88
You can adjust the quality and speed of the recording process using the settings described in this section.
Use / / / and SELECT to set the parameters.
When you are finished, use / / / to select “OK”
and press SELECT. The changes you make are
reflected in the MusicCAST server, and the on-screen
display returns to the screen it was previously
displaying. Select “Cancel” to return to the previously
displayed screen without making any changes.
Making a high quality recording
Place a check in the “Audio Master” checkbox to
enable the Advanced AudioMASTER™ function. Use
this function to make high-quality CD recording.
• The Advanced AudioMASTER™ function is only available
when you are recording to a new CD-R.
• The Advanced AudioMASTER™ function reduces the
maximum amount of material the MusicCAST server can
record to a CD. When using Advanced AudioMASTER™ to
record a CD, 74 minute CD will hold 63 minutes worth of
material, and 79 minute CD will hold 68 minutes of
material.
Selecting a recording format
Select “Digital” under the “Type” heading to record in
digital format, or “Analog” to record in analog format.
If you select digital, and digital copying is possible, the
MusicCAST makes a digital copy. If digital copying is
not possible, the MusicCAST moves the material to the
CD-R/CD-RW, and deletes it from its hard disk drive, in
a digital move process.
Setting recording speed
Select “x1” under the “Speed” heading to record at
normal playback speed, and “Best effort” to record at
the fastest speed possible under current conditions.
Setting the Recording auto level
function
The MusicCAST server can automatically adjust
recording levels (auto level). Place a check in the
“level” checkbox to enable the auto level function, or
remove it to disable the function.
NOTE
This function changes the volume of songs during recording.
To retain the original volume of songs, disable this function by
removing the check from the “Level” checkbox.
Setting recording parameters