Yamaha mcx-1000 - Manual (Page 16)

Getting started
16
Preparing the MusicCAST server
remote control
■ Inserting the batteries
1 Remove the cover on the underside of the
remote control.
2 Insert two AA batteries into the battery
compartment, checking that the positive (+) and
negative (–) terminals on the batteries
correspond to the polarity markings on the
case.
3 Slide the cover back until it snaps into place.
■ Battery replacement
If you find that the remote control must be used closer
to the main unit than usual, the battery is weak.
Replace the battery with new one.
■ Notes on batteries
• Please use AA size batteries.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline
and manganese batteries) together.
• Do not use rechargable batteries.
• Remove the batteries from the remote control if you do
not intend to use it for an extended period.
• If the battery leaks, dispose of it immediately. Avoid
touching the leaked material or letting it come in contact
with clothing, etc. Skin contact may cause burn. If it
occurs, wash with water promptly and get medical
attention.
• Do not connect the positive (+) and negative (–) terminals
of any one-battery together.
■ Using the remote control
• If using this remote control causes other equipment to
malfunction, change the location of the equipment.
• Do not spill water or other liquids on the remote control.
• Do not store or leave the remote control in conditions of
high temperature or humidity, such as near a stove, heater,
or bath.
• Do not place the MusicCAST server in locations where the
signal receiver will be in direct sunlight or near lighting
equipment. The remote control may not function correctly
in these conditions.
Preparing the remote controls
1
2
3
30
30
Approx. 6m
Signal receiver