Yamaha mcx-1000 - Manual (Page 139)

Appendix
Appendix
139
The time setting on the MCX-
1000 is in correct. The power cord has been disconnected
from an AC outlet for more than 1
minute.
→ The MCX-1000 holds backup data
for no longer than 1 minute after the
power cord is disconnected from the
AC outlet. Disconnecting it for
longer than this will reset the internal
clock. Reconnect the power cord
within one minute of disconnection.
There is a gap between MP3
songs. MP3 songs are encoded individually. This is not a defect in the MCX-1000.
There is no sound from analog
inputs. The external component is not
connected correctly. Correct the component correctly.
The external component volume is low. Increase the volume of the output from
the external component.
Playback is delayed or starts at
the wrong place on the CD. The CD is scratched or dirty. Check the CD, and replace it if
necessary.
The speakers emit a humming
sound. Connect your components correctly. Connect the stereo pin cables firmly.
The remote control does not
appear to function correctly. The batteries in the remote control are
exhausted. Replace both batteries with new ones.
You are attempting to operate the
MCX-1000 from too far away.
You are not aiming the remote
controller at the MCX-1000. Use the remote control within a 60
degree arc, no further than 6 meters
from the MCX-1000.
Bright light (such as sunlight or light
from a fluorescent lamp) is striking the
remote control sensor. Relocate the MCX-1000 so that no
bright light strikes the remote control
sensor.
Using the remote contol causes
problems operating your
television. You are using the remote control near a
television you can also operate with a
remote control. Relocate the MCX-1000 or cover the
remote control sensor of the television.
Functioning of your TV is
impaired. The television is using an indoor
antenna. Use an outdoor antenna with your
television.
Playback on the MCX-A10 skips
or pauses. You are using close to the maximum
number of MCX-A10 units and
simultaneously playing, storing, or
editing on the MusicCAST server. Reduce the number of MCX-A10 units
to which the MCX-1000 is distributing
music, or stop any operation you are
performing on the MCX-1000.
SYMPTOM CAUSE REMEDY PAGE