ZyXEL Communications Prestige 1600 - Manual (Page 61)

Prestige 1600 Universal Access Concentrator
Remote Node Configuration 7-5
To configure the TCP/IP parameters of a remote node, first configure the two fields in Menu 11 - Remote Node
Profile, as shown.
Table 7-3 TCP/IP related fields in Menu 11.1 - Remote Node Profile
Field Description Option
Rem IP Address Enter the IP address of the remote gateway in
Menu 11.1 Remote Node Profile.
Edit IP Press [SPACE BAR] to select Yes and press
[ENTER] to go to Menu 11.3 - Remote Node
Network Layer Options. Yes/No
The following table shows the TCP/IP related fields in Menu 11.3 - Remote Node Network Layer Options.
Table 7-4 Remote Node TCP/IP Configuration
Field Description Option
Rem IP
Address This shows the IP address you entered for this remote node in
the previous menu, Remote Node Profile.
Rem IP
Subnet Mask Enter the subnet mask for the remote network.
My WAN
Addr Some implementations, especially the UNIX derivatives, require
the WAN link to have a separate IP network number from the
LAN and each end must have a unique address within the WAN
network number. If this is the case, enter the IP address
assigned to the WAN port of your Prestige 1600.
Note that this is the address assigned to your local Prestige
1600, not the remote router.
Network
Address
Translation Please see the NAT chapter for a more detailed discussion on
the Network Address Translation feature. The choices are Full
Feature, None and SUA Only. Full Feature
None and SUA
Only
Address
Mapping
Set= N/A
Enter the address mapping set you are applying to this remote
node. 255 is the default (read-only) SUA Only set. 1 to 4, 255
Metric The metric represents the “cost” of transmission for routing
purposes. IP routing uses hop count as the measurement of
cost, with a minimum of 1 for directly connected networks. Enter
a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In
practice, 2 or 3 is usually a good number. 1 to 15
Private This parameter determines if the Prestige 1600 will include the
route to this remote node in its RIP broadcasts. If set to Yes, this
route is kept private and not included in RIP broadcast. If No,
the route to this remote node will be propagated to other hosts
through RIP broadcasts. Yes/No
RIP
Direction= Press [SPACE BAR] to select the RIP direction from Both/In
Only/Out Only/None. Both/In
Only/Out
Only/None
Version= Press [SPACE BAR] to select the RIP version from RIP-1/RIP-
2B/RIP-2M. RIP-1/ RIP-2B/
RIP-2M