ZyXEL Communications Prestige 1600 - Manual (Page 136)

Prestige 1600 Universal Access Concentrator
16-2 IP Policy Routing
Menu 25 shows all the policies defined.
Figure 16-1 Menu 25 - IP Routing Policy Setup
To setup a routing policy, follow the procedure below:
Step 1. Enter 25 in the Main Menu to open Menu 25 - IP Routing Policy Setup.
Step 2. Enter the index of the policy set you wish to configure to open Menu 25.1 - IP Routing Policy
Summary.
Menu 25.1 shows the summary of a policy set, including the criteria and the action of a single policy, and whether
a policy is active or not. Each policy contains two lines. The former part is the criteria of the incoming packet, and
the latter is the action. Between these two parts, separator ‘|’ means the action is taken on criteria matched and
separator ‘=’ means the action is taken on criteria not matched.
Figure 16-2 Menu 25 - IP Routing Policy Summary
Menu 25.1 - IP Routing Policy Summary
# A Criteria/Action
- - -------------------------------------------------------------------
1 Y SA=1.1.1.1-1.1.1.1,DA=2.2.2.2-2.2.2.5
SP=20-25,DP=20-25,P=6,T=NM,PR=0 |GW=192.168.1.1,T=MT,PR=0
2 N ___________________________________________________________________
___________________________________________________________________
3 N ___________________________________________________________________
___________________________________________________________________
4 N ___________________________________________________________________
___________________________________________________________________
5 N ___________________________________________________________________
___________________________________________________________________
6 N ___________________________________________________________________
___________________________________________________________________
Enter Policy Rule Number (1-6) to Configure:
Menu 25 - IP Routing Policy Setup
Policy Policy
Set # Name Set # Name
------ ----------------- ------ -----------------
1 test 7 _______________
2 _______________ 8 _______________
3 _______________ 9 _______________
4 _______________ 10 _______________
5 _______________ 11 _______________
6 _______________ 12 _______________
Enter Policy Set Number to Configure= 0
Edit Name= N/A
Press ENTER to Confirm or ESC to Cancel: