ZyXEL Communications 128MH - Manual (Page 76)

Prestige 128MH PSTN Router/Hub
4-6 Chapter 4 Telecommuting
Table 4-2. Default Dial-in Setup Fields (continued)
Field Description Option
Multiple Link Options: Max
Port Enter the maximum number of ports in a connection
between your Prestige and the Remote Dial-in User. Default = 1
Callback Budget
Management: Allocated
Budget (min) This field will set a budget callback time for all the
Remote Dial-in Users. The default for this field is [0] for
no budget control. Default = 0
Callback Budget
Management: Period (hr) This field will set the time interval to reset the above
callback budget control.
Dial-In IP Address Supplied
By: Dial-in User If set to [Yes], it tells your Prestige to allow a remote host
to specify its own IP address. This is to prevent the
remote host from using an invalid IP address and
potentially disrupting the whole network.
If set to [No], the remote host must use the IP address
assigned by your Prestige from the IP pool, configured
below.
(Default = Yes)
[Yes/No]
Dial-In IP Address Supplied
By: IP Pool This field tells your Prestige to provide the remote host
with an IP address from the pool. This field is required if
Dial-In IP Address Supplied By: Dial-in User is set to [No].
You can configure this field even if Dial-in User is set to
[Yes], in which case your Prestige will accept the IP
address if the remote peer specifies one; otherwise, an IP
address is assigned from the pool. [Yes/No]
(Default = No)
IP Pool: IP Start Addr This field is active only if you selected [Yes] in the Dial-In
IP Address Supplied By: IP Pool field.
The IP pool contains contiguous IP addresses and this
field specifies the first one in the pool.
IP Count (1-3) In this field, enter the number ([1], [2], or [3]) of the
addresses in the IP Pool. For example, if the starting
address is 192.168.135.5 and the count is [2], then the
pool will have 192.68.135.5 and 192.68.135.6 [1], [2], [3]