ZyXEL Communications 128MH - Manual (Page 74)

Prestige 128MH PSTN Router/Hub
4-4 Chapter 4 Telecommuting
4.3 Default Dial-In Setup
This section covers the default dial-in parameters. The parameters in Menu 13 affect incoming
calls from all Remote Dial-in Users and Remote Nodes before authentication is completed. Once
authentication is completed, and if it matches a Remote Node, your Prestige will use parameters
from that particular Remote Node.
Figure 4-3. Menu 13 - Default Dial-in Setup
From the Main Menu, enter 13 to go to Menu 13 - Default Dial-in Setup. This section will
describe how to configure the protocol-independent fields in this menu. For the protocol-
dependent fields, refer to the appropriate chapters.
Table 4-2 describes and contains information on how to configure each parameter in Menu 13 -
Default Dial-in Setup.
Menu 13 - Default Dial-in Setup
Telco Options:
CLID Authen= None
PPP Options:
Recv Authen= CHAP/PAP
Compression= Yes
Mutual Authen= No
PAP Login= N/A
PAP Password= N/A
Multiple Link Options:
Max Ports= 2
Callback Budget Management:
Allocated Budget(min)=
Period(hr)=
IP Address Supplied By:
Dial-in User= Yes
IP Pool= No
IP Start Addr= N/A
IP Count(1,3)= N/A
IPX Net Num Supplied By:
IPX Pool= No
IPX Start Net Num= N/A
IPX Count(2,16)= N/A
Session Options:
Input Filter Sets=
Output Filter Sets=
Idle Timeout= 300
Press ENTER to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.