ZyXEL Communications 128MH - Manual (Page 165)

Prestige 128MH PSTN Router/Hub
13-13 Chapter 13 System Maintenance
Figure 13-10. Menu 24.7 - System Maintenance - Upload Firmaware
13.7.1 Load RAS code
Type [atur] and wait until your Prestige responds with an [OK] to begin uploading the new
software (upload procedure varies depending on the type of software used to access your
Prestige). You must use the XMODEM protocol to perform the upload. After uploading is
successful, type [atgo] to start your Prestige. Below is an example of downloading RAS using
PCPLUS.
Figure 13-11. Menu 24.7.1 - Example of Uploading RAS Using PCPLUS
Menu 24.7 -- System Maintenance - Upload Firmware
1. Load RAS Code
2. Load ROM File
3. Load WAN Port 2 Modem Firmware
4. Load WAN Port 3 Modem Firmware
Enter Menu Selection Number:
Menu 24.7.1 -- System Maintenance - Upload RAS Code
To load the RAS code, type "atur" while in debug mode and wait for
"Starting XMODEM upload" before beginning to upload code.
Type "atgo" after code has successfully loaded to start RAS.
Proceeding with the upload will erase the current RAS code.
Do You Which To Proceed:(Y/N)