ZyXEL Communications ACCESSING INTERNET & INTRANET omni series - Manual (Page 22)

10 Installing omni External Models
PHONE 2 (omni.net) - RJ-11 terminal jack for analog adapter 2; for
connecting to analogue equipment.
O
NOTE
: The signal-pin assignment of the RJ-45 and RJ-11 phone jacks
are listed in Chapter 18.
Connecting to the Power Supply
To Connect your omni to the power supply, follow the steps given
below:
1. Turn off your computer.
2. Make sure the power switch on the TA is in the OFF (down)
position.
3. Connect the round end of the power adapter to the POWER
JACK on the TA’s back panel.
4. Plug the power supply unit to an AC wall jack then power on the
TA.
5. Observe the LED light status on the front panel of your TA and
make sure PWR LED is on.
O NOTE
: Use only the power adapter supplied with your TA. Never use a
power adapter designed for a different product.
Connecting to Your Computer
Your TA comes with a 25 pin, male to female cable, which is to be
used to connect the main serial port of TA to your computer serial
port as seen in the figure below: