ZyXEL Communications V501-T1 - Manual (Page 145)

Chapter 7 LCD Menus: Advanced
V500 Series User’s Guide
145
7.5.1 Protocol
Use this screen to see or edit the protocol that the V500 uses to request and receive the auto-
provisioning file. This protocol must be the same as that used by the auto-provisioning server.
Enable and select Advanced Setting > Auto Provision > Protocol. The following screen
displays.
Figure 106 LCD Menu: Auto Provision Protocol
The following table describes the labels in this screen.
7.5.1.1 Auto Provision Protocol - Edit
Press Edit in the Auto Provision Protocol screen. The following screen displays.
Expire Time Select this to see or edit how long the V500 waits after it successfully
receives an auto-provisioning file before it requests another.
Retry Time Select this to see or edit how long the V500 waits, if it requests an auto-
provisioning file but does not receive one, before requesting the file again.
Select Press this to choose the highlighted entry in the menu.
Back Press this to return to the previous screen without saving your settings.
Table 80 LCD Menu: Auto Provision
LABEL DESCRIPTION
Auto Provision Protocol
Current: HTTP
Edit Back
Table 81 LCD Menu: Auto Provision Protocol
LABEL DESCRIPTION
Current This shows the auto-provision protocol already configured on the V500.
Edit Press this to change the auto-provision protocol.
Note: The V500 must use the same protocol as the auto-
provisioning server.
Back Press this to return to the previous screen.