Quantum Data 801GC - Manual (Page 333)

8-25
9470 Can’t change EPROM contents
An attempt was made to insert a format using the FMTI
command into an EPROM format memory location.
■
Use a range of 1 through 300 as the insertion location
for formats in nonvolatile RAM.
9471 Bad location for format yank
This occurs when you try to remove (yank) one or more
formats from invalid format memory locations using the
FMTY command.
■
All formats to be removed from nonvolatile RAM must
be in the range of memory locations 1 through 300.
9472 Can’t change EPROM contents
This occurs when you try to remove (yank) one or more
formats from EPROM format memory locations using the
FMTY command.
■
Only formats in memory locations 1 through 300 can
be removed.
9475 Can’t change EPROM contents
One or more EPROM format locations was given as the
destination location for the FMTD command.
■
Use a range of 1 through 300 as the destiny location
to copy formats to nonvolatile RAM.
9477 Error duplicating formats
The memory location parameter used with the FMTD
command is greater than the memory location
parameter.
■
Make the memory location parameter less than
or equal to the memory location parameter.
9480 Format data missing
The FMTR command tried to read a format from an empty
format storage location.
■
Use a memory location known to contain a format or
use the FMTL command to load a format by name.