Quantum Data 801GC User Manual
Page 276
6-150
Chapter 6: Programming
Model 801GC, 801GF & 801GX¥Rev. A
MODE
communications MODE
Classification:
System parameter setting
Command Syntax:
MODE
protocol>]]]]]
Limits:
300, 600, 1200, 2400, 4800, 9600, 19200 or 38400 bits/
sec
N = None, E = Even or O = Odd
<# data bits>
7 or 8
<# stop bits>
1 or 2
N = None, S = Software (XON/XOFF) or
H = Hardware (CTS/RTS)
< protocol >
N = None, Y=Y-Modem
Query Syntax:
MODE?
Query Response:
or
Description:
The MODE command is normally used to set the serial port
communications parameters of a stand-alone model generator.
The changes take effect as soon as the command is entered. The
command has no affect on the ISA addressing configuration of
the -ISA model generators. The MODE? query returns the current
serial port communications settings of a stand-alone generator
or the ISA address of an -ISA model generator.
Other Required Cmds:
None
E x a m p l e s :
M O D E 9 6 0 0 N 8 1 H N / / S e t a s t a n d
/ / a l o n e g e n e r a t o r t o c o m m u n i c a t e
/ / a t 9 6 0 0 B a u d , N o p a r i t y , 8 d a t a
/ / b i t s , 1 s t o p b i t , R T S / / C T S
/ / h a n d s h a k i n g a n d N o p r o t o c o l
or
M O D E 2 4 0 0 / / C h a n g e o n l y t h e b a u d r a t e