Oki C 9400 - Manual (Page 386)

Important! DIMMs must be installed in the slots in the following sequence: 1 - 3 -
2 - 4. The slot numbers are printed to the right of the DIMM sockets.
DIMM Sockets
2. Push out the white lock tabs at either end of the DIMM socket.
Note: To swap out an existing DIMM board for a new one, push out the white tabs at
either end of the board to be replaced, then lift it out.
Caution! Circuit boards can be damaged by static electricity and rough handling.
To avoid damage, ground yourself before handling DIMMs.
3. Remove the DIMM from its shipping package.
4. Align the DIMM with the narrow strip on its metallic contact edge to the right (toward the
slot identifier numbers ) of the control board.
385