Omega Vehicle Security OMP-MODL - Manual (Page 243)

11.. . A PPENDIX A: M ASTER I CON R EFERENCE
U SING THE OMP-MODL 11-81
CONFIGURATION OPTIONS:
Icon Name: Specify the label for the icon. This name will show directly under the icon
within the Program Net.
Input Name: In this box, HyperNet displays the Output Name of the icon connected to
this icon’s Input. The Output Name can be changed in the other icon’s
dialog.
Output Count after ____ input transitions received: When the number of
transitions received on the Up Counter’s Input equals this User supplied
value, the value is passed to the Output and the count resumes again at 0.
Count Rising / Falling Edges: The Up Counter increments its accumulated count
when its input changes state. The User can use this option to specify
whether Rising (False to True) or Falling (True to False) transitions
(edges)are to be counted.
Output Count upon disable: Check this box to force an output of the accumulated
Count at any time that the icon is disabled. If this box is not checked, upon
receipt of a disable signal, the Counting function will be momentarily
suspended until the icon is re-enabled and no in-process value will be
output.
For example, if a Count is to be output after 100 samples have been
received but only 60 have been received and the icon is disabled, the 60
sample Count total will be output and the counting function will be
suspended until re-enabled. Upon re-enable,counting will continue and
after 40 more samples are received, the 100 sample Count Total will be
output (unless the following check box is checked)
Clear Transition and Input Counts upon Enable: Check this box to force a reset of
the accumulated Count Total as well as the Sample count used used for the
calculation upon receipt of an Enable signal.
If this box is not checked, upon receipt of an Enable signal, counting
calculation will proceed from its suspended state (that it entered when it
was disabled).
Clear Counter on Output: Check this box to force the Count Value to be reset to 0
after Output. If this box is not checked, the icon will perform as a counting
totalizer
Units: Provides a text box for User entry of a units label that will be shown at the
output from this icon. Conversion to other units can be performed within a
Program Net by adding a Math Icon onto this icon’s output.
Output Name: Specify the label for the Output. This name will show directly
under the Output terminal within the Program Net.