Roland RM-700 - Manual (Page 169)

170
Creating and Editing Songs
3. Touch .
The “Composer” screen appears.
4. Touch the to select “Tempo.”
This makes the setting for tempo recording.
Press the [Exit] button a number of times to switch to the screen
where the measure number is indicated in the upper right of the
screen.
When the RM-700 goes into Tempo Recording, the tempo indication
is highlighted.
Recording the Tempo
5. Access the DigiScore screen (p. 106), and use the [Value]
dial to move to a point slightly earlier than the measure
at which you want to change the tempo.
6. Press the [ (Rec)] button so its indicator is flash.
The RM-700 is put in recording standby.
7. When you press the [ (Play/Stop)] button,
recording begins.
8. When you get to the place where you want to change the
tempo, use the Tempo [Slow] and [Fast] buttons or the
dial to vary the tempo as desired.
9. When you press the [ (Play/Stop)] button,
recording stops.
The song’s tempo changes.
You cannot record performances while in Tempo Recording
mode. When you’re finished tempo recording, go back to the
ordinary Replace Recording.
You can create a tempo change at the beginning of a selected
measure. This is handy when you want to make a sudden change in
tempo.
First, carry out Steps 1–4 of “Changing the Tempo Within the Song”
(p. 169) to make the “Tempo Recording” settings.
1. Access the DigiScore screen (p. 106), then use the [Value]
dial to move to the measure for which you want to
change the tempo.
The measure number appears in the top-right area of the Basic
screen.
2. Press the [ (Rec)] button so its indicator is flash.
The RM-700 is put in recording standby.
3. Use the Tempo [Slow] [Fast] buttons or the dial to change
the tempo.
4. Press the [ (Play/Stop)] button.
The song’s tempo changes starts with the measure you selected.
While tempo recording is being used to write tempo, the
tempo display in the screen will be highlighted.
5. When you press the [ (Play/Stop)] button, the
change in tempo stops.
You cannot record performances while in Tempo Recording
mode. When you’re finished tempo recording, go back to the
ordinary Replace Recording.
If you want to restore the previous tempo, delete the tempo
data at the place where the tempo was recorded. For an
explanation of how to delete the information of tempo
settings, refer to “Making Measures Blank (Erase)” (p. 167).
Adjusting the Tempo at a Particular Measure
Tempo Recording Shortcut
Hold down the [ (Rec)] button and press one of the Tempo
[Slow] [Fast] buttons to switch to the Tempo Recording settings.
Record tempo information. In this case, tempo recording is
canceled when recording ends.
RM-700_e.book 170 ページ ２００９年３月１８日 水曜日 午前１１時５分