Roland Classic Organ C-380 - Manual (Page 36)

36
Performing
You can make additional changes to the reverberation by changing the wall type (the material out of which the wall is constructed).
1. From the main screen, press the [Select/Menu] knob.
2. Turn the [Select/Menu] knob to select “4 Room Modeling.”
fig.LCD005.eps
3. Press the [Select/Menu] knob to access the “Room Modeling” screen.
You can also access the “Room Modeling” screen from the main screen by holding in the [SET] piston and turning the
[Reverb] knob.
4. Turn the [Select/Menu] knob to select “Wall Type.”
fig.LCD022.eps
5. Turn the [Value/Exit Menu] knob to change the Wall Type setting.
6. Press the [Value/Exit Menu] knob twice to return to the main screen.
This setting will return to the default value when you turn off the power, but you can store the setting so that it will be
remembered even after the power is turned off. For details, refer to “Storing Your Settings (Customize)” (p. 73).
Changing the Wall Type
Type Explanation
DRAPERY Pleated curtains
WOOD Wood
BRICK Brick
MARBLE Marble
C-380_330_e.book 36 ページ ２０１０年４月２８日 水曜日 午後１０時１１分