Roland Classic Organ C-380 - Manual (Page 19)

19
Before You Start Playing
* The illustration shows the C-330, but the connections are the same
for the C-380 as well.
1. Adjusting the pedalboard adjuster.
Turn the pedalboard adjuster (four locations) to lower it until the
pedalboard does not wobble.
* If there is a gap between the pedalboard and the floor, the
pedalboard may be damaged.
* In particular when placing the instrument on carpet, adjust this so
that the pedalboard firmly contacts the floor.
2. Connect the cable extending from the bottom of the
main unit to the PEDAL OUT jack of the pedalboard.
3. Place the pedalboard.
Place the pedalboard so that it contacts the organ.
1. Gently raise the music rest, then secure it in place as
shown in the figure.
2. To collapse the music rest, fold in the metal fittings while
supporting the music rest with both hands and gently
fold down the music rest.
Do not pull down the music stand.
* The illustration shows the C-330, but the connections are the same
for the C-380 as well.
1. Place the organ bench over the pedalboard.
As shown in the illustration, position the bench so that the side with
the footrest faces the organ, taking care that the footrest does not
touch the pedalboard.
Turn the bench adjusters (four locations) to lower them, adjusting
the height so that the bench does not wobble.
Do not adjust the adjusters more than 25 mm (1 inch) from the
floor.
Connecting the Pedalboard
Please don’t get your
fingers pinched.
Adjuster
Please don’t get your
fingers pinched.
Using the Music rest
Placing the Bench
Metal Fittings
Adjuster
Please don’t get your
fingers pinched.
less than
25 mm
(1 inch)
C-380_330_e.book 19 ページ ２０１０年４月２８日 水曜日 午後１０時１１分