Nortel Networks ALTEON OS BMD00007 - Manual (Page 273)

Alteon OS Command Reference
The Configuration Menu „ 275 BMD00007, November 2007
/cfg/l3/ospf/if
OSPF Interface Configuration
disable
Disables the OSPF summary range.
delete
Deletes the OSPF summary range.
current
Displays the current OSPF summary range.
[OSPF Interface 1 Menu]
aindex - Set area index
prio - Set interface router priority
cost - Set interface cost
hello - Set hello interval in seconds
dead - Set dead interval in seconds
trans - Set transit delay in seconds
retra - Set retransmit interval in seconds
key - Set authentication key
mdkey - Set MD5 key ID
enable - Enable interface
disable - Disable interface
delete - Delete interface
cur - Display current OSPF interface configuration
Table 6-72 OSPF Interface Configuration Menu Options (/cfg/l3/ospf/if)
Command Syntax and Usage
aindex
Configures the OSPF area index.
prio
Configures the priority value for the GbE Switch Module’s OSPF interfaces.
(A priority value of 255 is the highest and 1 is the lowest. A priority value of 0 specifies that the
interface cannot be used as Designated Router (DR) or Backup Designated Router (BDR).)
cost
Configures cost set for the selected path—preferred or backup. Usually the cost is inversely pro-
portional to the bandwidth of the interface. Low cost indicates high bandwidth.
Table 6-71 OSPF Summary Range Configuration Menu Options (/cfg/l3/ospf/range)
Command Syntax and Usage