Nortel Networks ALTEON OS BMD00007 - Manual (Page 22)

Alteon OS Command Reference
22 „ The Command Line Interface BMD00007, November 2007
Figure 1-1 Switch management on the BladeCenter management module
4. You can use the default IP addresses provided by the management module, or you can
assign a new IP address to the switch module through the management module. You can
assign this IP address through one of the following methods:
„
Manually through the BladeCenter management module
„ Automatically through the IBM Director Configuration Wizard (available in
Director release 4.21)
N OTE – If you change the IP address of the GbE Switch Module, make sure that the switch
module and the management module both reside on the same subnet.