Nortel Networks 8010co - Manual (Page 41)

Chapter 2 Installation 41
Installing the Breaker Interface Panel for the Ethernet Routing Switch 8010co Chassis
3 Loosen the 2 retaining screws on the power supply located in bay 1 in the
lower chassis (
Figure 20 ).
Figure 20 Loosening the power supply retaining screws
4 Lift the extractor lever to disconnect the power supply from the backplane
connector, and then pull the power supply partially out of the chassis
(
Figure 21 ).
Figure 21 Disconnecting the power supply from the chassis backplane
10424FA
+DC
-DC
+DC
-DC
+DC
-DC
10425FA
+DC
-DC
+DC
-DC
+DC
-DC