Nortel Networks 8010co - Manual (Page 39)

Chapter 2 Installation 39
Installing the Breaker Interface Panel for the Ethernet Routing Switch 8010co Chassis
To connect cables to the chassis power supplies:
1 Remove the 8010co chassis bottom bezels (if required).
a Using a Phillips screwdriver, loosen the 2 captive screws securing the
bezel to the chassis (
Figure 18 ).
b Pull the top of the bezel forward and then lift the 312096-A bezel from the
two tabs on the bottom of the chassis.
c Repeat steps a and b for the second chassis, if installed.
Figure 18 Removing the 8010co chassis bottom 312096-A bezel
Fail Pass
Fail Pass
10422FA
Bottom bezel