Nikon CAPTURE NX2 - Manual (Page 143)

Chapter 15 — Edit List | Develop Section 141
When this lens information is not available, the
Intensity slider’s range will be based on default lens
characteristics. To determine whether a given combination of lens and camera will record distance
information, see the table below.
To apply vignette control to your image, follow these steps:
If you would like to remove the vignette control effect, click on the
Reset button or uncheck the “Apply”
checkbox next to
Vignette Control.
Camera Type G or D lens Any other type of lens
D40, D40X, D50, D60, D70, D70S, D80, D100,
D2H, D2HS, D2X, D2XS, D200, D3, D300 Distance information
recorded Distance Information
not recorded
D1X/D1H
(firmware version 1.10 or later) Distance Information
recorded Distance Information
not recorded
D1X/D1H
(firmware version 1.01 or earlier) Distance Information
not recorded Distance Information
not recorded
D1
Distance Information
not recorded Distance Information
not recorded
1
Click on the show/hide triangle next to Camera &
Lens Corrections.
2
Drag the Intensity slider to the right to brighten the
edges of the currently active photo, or drag the
Intensity slider to the left to darken the edges of the
photo.
If the image was taken under any situation in which
the distance information was not recorded, please
take care when adjusting the vignette control
settings so as to not over apply vignette control.