National Instruments FP-3000 - Manual (Page 106)

Appendix C FP-3000 Specific Parameters
FieldPoint FP-3000 User Manual C-4 www.ni.com
DEV_OPTS
A list of device-wide options that can be turned on and off at will.
The current firmware supports only one option.
EN_CLOSE
Enables the Close command from parameter OP_CMD_CXO . If EN_CLOSE
is not set, then OP_CMD_CXO Close commands will be ignored.
EN_OPEN
Enables the Open command from parameter OP_CMD_CXO . If EN_OPEN is
not set, then OP_CMD_CXO Open commands will be ignored.
EVENT_0—EVENT_19
The last 20 events.
EVENT_FILTER
Restricts the entries shown in the log of the Log Block. The values are a
combination of
Configuration Error , Operational Warning , and
Operational Error .
EXECUTION_STATISTICS
A repository containing performance statistics for a given block. Use
EXECUTION_STATISTICS to assess the performance of a given
configuration and allow appropriate changes to be made.
Table C-4. Device Options
Options Description
Disable CFG_OPTS in all I/O blocks This bit disables all block configuration options in
CFG_OPTS . It is not recommended that this bit be set since
the additional behavior can make configuration easier.